M1917 light tank

From Infogalactic: the planetary knowledge core
Jump to: navigation, search

Lua error in package.lua at line 80: module 'strict' not found.

M1917
M1917 Tank.jpg
M1917 tank at Ropkey Armor Museum
Type Light tank
Place of origin  United States
Specifications
Weight 7.25 tons
Length 16'5"
Width 5'10 1/2 "
Height 7'7"
Crew 2

Armor 0.25" to 0.6"
Main
armament
37mm M1916 gun or Marlin M1917 machine gun, later replaced by the M1919 Browning machine gun[1]
Secondary
armament
none
Engine Buda HU modified 4-cylinder, with forced water cooling
42 HP
Transmission sliding gear, 4 speed forward, 1 reverse
Suspension coil and leaf springs, with bogies and rollers.
Fuel capacity 30 gallons (30 miles on the road)
Operational
range
48 km (30 miles) on road.
Speed 8 km/h (5.5 mph)

The M1917 was the USA's first mass-produced tank, entering production shortly before the end of World War I.[2] It was a license-built near-copy of the French Renault FT,[2] and was intended to arm the American Expeditionary Forces in France, but US manufacturers failed to produce any in time to take part in the War. Of the 4,440 ordered, about 950 were eventually completed. They remained in service throughout the 1920s but did not take part in any combat, and were phased out during the 1930s.

History

The USA entered the First World War on the side of the Entente Powers in April, 1917, without any tanks of her own. The following month, in the light of a report into British and French tank theories and operations, the American Expeditionary Forces' commander-in-chief, Gen. John Pershing, decided that both light and heavy tanks were essential for the conduct of the war and should be acquired as soon as possible.[3] A joint Anglo-American programme was set up to develop a new type of heavy tank similar to those then in use by the British. It was, though, expected that sizeable quantities would not be available until April of the following year. Because of the wartime demands on French industry, the Inter-Allied Tank Commission decided that the quickest way to supply the American forces with sufficient armour was to manufacture the Renault FT light tank in the USA.

A requirement of 1,200 was decided, later increased to 4,400, and some sample Renault tanks, plans, and various parts were sent to the US for study. The design was to be carried out by the Ordnance Department, under the job title "Six-ton Special Tractor," and orders for the vehicles placed with private manufacturers. However, the project was beset by problems: the French specifications were metric and incompatible with American (imperial) machinery; coordination between military departments, suppliers, and manufacturers was poor; bureaucratic inertia, lack of cooperation from military departments, and possible vested interests delayed progress.

The Army in France was expecting the first 300 M1917s by April, 1918. In the event, production did not begin until the autumn, and the first completed vehicles emerged only in October. Two tanks arrived in France on November 20, nine days after the end of hostilities, and a further eight in December. In the summer of 1918, with no sign of the M1917s and US troops desperately needed at the Front, France supplied 144 Renault FTs, which were used to equip the US Light Tank Brigade.

After the war, the Van Dorn Iron Works, the Maxwell Motor Co., and the C.L. Best Co. built 950 M1917s. 374 had cannons, 526 had machine guns, and 50 were signal (wireless) tanks. These were delivered to the Tank Corps, to complement about 200 Renault FTs brought back from France.

Visible differences from the Renault FT

The M1917 can be distinguished from the Renault FT by means of several external features.

  • The exhaust is on the left hand side instead of on the right
  • The FT mantlet for the machine-gun or 37mm cannon is replaced with a new design.
  • Solid steel idler wheels replaced the steel-rimmed, wooden or seven-spoked steel ones on the FT
  • Additional vision slits are added to aid the driver .
  • All M1917s have a polygonal turret; none used the circular turret type fitted to approximately 50% of Renault FTs.
  • The frontal armour below the turret was also slightly modified.
  • The track tensioning mechanisms which move the idler wheels forward or aft) differ; the M1917 has an assembly in which a bolt is used to set the tension, and 2 pairs of interlocking toothed plates lock together to hold the axle in place, removing strain from the relatively weak bolt.

Operational use

M1917 tank at the Canadian War Museum

The M1917 did not take part in any combat.

In June 1920 the Tank Corps was abolished as a separate branch, and control of tanks handed to the infantry. The number of tank units was progressively reduced, and the vehicles mothballed or scrapped.

Five accompanied the U.S. Marine Expeditionary Force to Tientsin in April 1927 under General Smedley Butler, but there is no record of shots being fired. They returned to the USA in late 1928.[4]

In July 1932 six M1917s were deployed in Washington D.C. during the dispersal of the Bonus Army. George S. Patton Jr. states in his diaries that these vehicles were carried in trucks as a deterrent, but contemporary film shows them moving on their tracks along Pennsylvania Avenue.[5] It is not believed that any shots were fired.

In 1940 the Canadian Army bought 250 surplus examples at scrap value (about $240 each) and the Royal Canadian Armoured Corps gained valuable experience and training on them before embarking to Europe and using the more modern equipment. The Canadian Army took delivery of 236 surplus M1917s. Fifteen of them apparently went to Camp Borden for training use, while others went to train individual units such as the Fort Garry Horse and possibly another three.

Variant

M1917 A1: In 1929 an M1917 was fitted with a Franklin six-cylinder, 67 hp, air-cooled engine. This involved lengthening the engine compartment by approx. 1 foot. In 1930-31 seven M1917s were fitted with the 100 hp version of the Franklin. This raised the top speed to 9 mph.

Surviving Examples

Approximately 20 M1917s survive.[6]

Depiction in films

M1917s were used by U.S. film-makers on numerous occasions as a substitute for Renault FTs, to depict either American tank actions during World War I or Renaults in use by European armies during and after the War.[2]

See also

References

Notes
  1. Lua error in package.lua at line 80: module 'strict' not found.
  2. 2.0 2.1 Zaloga (Armored Thunderbolt) p. 2
  3. Treat 'Em Rough!
  4. Zaloga, S.J. US Marine Corps Tanks of World War II (New Vanguard, 2012) p5.
  5. [1] British Pathe
  6. http://the.shadock.free.fr/Surviving_6ton_M1917.pdf
Bibliography
  • US M1917 tanks in the Canadian Army, Popular Science, January, 1941
  • The Encyclopaedia of Tanks and Armoured Fighting Vehicles; Published in 2007 by Amber Books Ltd.
  • Zaloga, Steven J. Armored Thunderbolt, The US Army Sherman in World War II. 2008, Stackpole Books. ISBN 978-0-8117-0424-3.
  • Treat 'Em Rough; Dale E. Wilson, pub. Presidio, 1989.
  • U.S. Military Tracked Vehicles; Fred W. Crismon, pub. Crestline, 1992.
  • The Fighting Tanks Since 1916; Jones, Rarey, & Icks, pub. We Inc., 1933.
  • Armoured Fighting vehicles of the World: Vol 1; Various, pub. Cannon Books, 1998.
  • The Patton Papers, 1885-1940; Martin Blumenson, ISBN 0735100764.
  • America's Munitions 1917-1918, Report of Benedict Crowell, the Assistant Secretary of War, Chapter 8 "Tanks", Washington Government Printing Office, 1919.

External Links